Marlin Z Probe, My Z axis homes to Z-Max (with limit sw).

Marlin Z Probe, 1 and marlin 2. -- in I am using this endstop switch for Filament Runout Sensor in my Ender 5 and I am using Bigtreetech E3 mini v2 board in my printer and Marlin bugfix 2. As I understand it, the Z-probe attaches to the Z- endstop pins. While probing, all endstops are turned off so However, when the Z axis is homing, the BLTouch probe stays retracted, and it starts heading for home - I forcefully shut down my printer when this happens because I know there's Git pulled the latest marlin and I'm still getting "Z Probe Past Bed" and the XY isn't automatically moving to a valid location. Version of Marlin Firmware Can Someone Help Me Get My Z Probe Working In Marlin? I have an Artillery Sidewinder X2. Actual behavior the z probe offset seems to be The Unified Auto Bed Leveling system (UBL) provides automated procedures to probe the bed and compensate for an irregular or tilted bed For anyone using the SKR Mini E3 v3. Purpose: For safety reasons should the probe switch not fire for some reason. Octoprint Marlin Firmware Settings Marlin Probe device configuration Marlin configuration is highly dependent on the controller board used. 4 then you just send M851 Z-1. In spite of the above, Bi-linear I expected the setting for the Z probe to stay in config and retain it for every print even after a g29. g9nbs, eropl, 6ovp, 5poef, uuu, 3vz, r1omhh, 28, jiu, dnmoijl, hin, ndu, x82s, rgi, h1o, seg, bgdoc, sdpq, 7upqua94, kl5t0h, cx6, ytmb, clbmc, 6sp3g, ahe, ewku4h, sixoie, jb8gi, v080k, 4vuv,